2004 XE 4X2

Present mods:

PML (TB crank, shackels
Custom audio setup
K&N drop in filter
CB Radio
5% tint on back, 35% tint on side

SOOOON to be mods: Total Chaos Long Travel Kit, Coil over conversion, Fiberglass fenders,

Future Mods: Deavers in the rear

 

Pics / Project thread

Here are some pictures I have been meaning to post. The set up is:

TC UCA
Radflo front coilovers
Radflo rear resi struts
PRG shackles
Deaver AAL
DIY 2" Body Lift
Procomp MT/ 7089 in 16x8
Shrock front bumper
Superwinch EP9 winch
In-cab winch wiring with arming switch for both inside/ outside
Cobra cb with radio shack antenna
Notched fender
Relocated body wiring harness.

In a few of the pictures, I had the Maxxis Bighorns in 255/85/16 prior to the body lift. Future plans call for building sliders and a rear bumper, and I plan to get a roof top tent / bed rack. Hope you enjoy...

 

 

2005 Frontier SE 4x2 6cyl

Suspension: 4" cst spindles, 3" prg spacers, 2" deavers, 2" blocks, prg adj. shackles, rear Titan SAW shocks

Interior: Custom 2 tone leather seats from Katzkins, pathfinder switch covers

System: JVC indash cd/dvd, polk audio momo 6.5" comps, polk audio momo 6.5 coaxials, JL 300/4, JL 500/1v2, 12w6v2 mounted in custom glassed box

Wheels/Tires: Pro Comp 7129 16x8 with Nitto Terra Grappler 295/75/16

Performance: WRP IMS, WRP TBS, WRP Ground kit, Nismo CAI

Misc: Colormatched headlights, hunter bull bar, blacked out billet grill/emblem, painted windshield cowl, painted dash gauge overlay, SS Ultra high/low bulbs, oem step bars, relocated 7 pin trailer plug, tinted windows, in channel window visors, bug shield


I know its not all major modifications but its a lot for me. I dont go wheelin like a lot of these people but dont mind it getting dirty every now and then. For now this is my list but I do have a few things that are on hold for the future.
1)Coilovers
2)exhaust/headers

 

FYI, as with all stickys--leave out the chatter or it will be deleted.
I'll stick this for now. If it isn't too popular, I'll un-stick it. If you posted here, you can link this thread (or specific post) in your signature.

Pics are always nice

 

holy crap... where do i start?

black 02 frontier xe with 4x4 conversion and sas'd three link front/rear.

drivetrain-
-front axle:
completely custom dynatrac pro rock 60 front axle. custom width, pinion angle, caster, pumpkin offset. 5.15 gears, arb air locker, warn heavy duty hubs. 35 spline chromoly shafts (inners and outers). bridge over pumpkin for upper link.

-rear axle:
nissan h233b rear axle. a/c 5.13 gears, arb air locker. custom plasma cut bracket for upper link.

-transfer case:
a/c crawler gears

-drive shafts
front/rear custo, shafts by unitrax

-engine:
stillen cold air intake
nismo cat back exhaust
permacool engine oil cooler with remote filter
permacool transmission cooler with filter
flex-a-lite black magic extreme efan. (3300 cfm pull)
optima yellow top (720 cca)
custom motor mounts

armor-
shrockworks front bumper
custom sliders
a/c rear diff skidd

lighting-
2 hella 500 series fogs

recovery-
warn M8000 winch
60" hi-lift
(1) 3"x30' 30K lb pro comp looped strap
(2) 2"x20' 10K lb tow straps
warn winch kit
(2) front clevises up front on bumper
(1) hitch mounted clevis

appearance-
painted front/rear fiberglass.
custom "nismo" logo painted into driver front fiberglass
tinted windows
halo headlights

suspension-
king 2.5", 14" travel coilover shocks (200/250 lb springs front)
king 2.0", 14" travel coilover shocks (100/250 lb springs rear)
3" hydro bumpstops up front

other fun stuff-
cobra 19 cb
4' firestik
ultimate air 10 lb co2 tank
staun tire deflaters
'tactical' red interior lights
sticker on rear tail gate- "don't follow me... you won't make it!"



thats all i can think of right now...

 

I'll give it a go:

KMA front bumper with 100W fogs
Badland Bumper's custom rock sliders with nifty bedliner coating
NISMO CAI
Rear license plate Backup camera
Valley hitch
Xtreme 48" hi-lift jack
Tailgate Utilitrack mod
Custom Cat-back w' Flowmaster 50 Series muffler
Summit (T-Max) 9K winch w/ wireless remote
Rear Diff Skidplate
Midland CB
Icom F521 VHF-High 2-way radio
Wilson Lil' Wil antenna
amber LED dash flashers
amber LED directional lightbar

Sitting on my garage floor:
PRG 3/2 lift: Spacers and Deavers
New Rear Bilsteins
TC UCA's

About to be installed:
Amber LED lightbar
Harley-Davidson clamp on fog lights

 

See sig...

 

see sig for some mods... maybe i will update a list once we get more than offroad rigs in here...

 

SUSPENSION:
FRONT: Sway-bar-less front with Radflo 2.0 coilovers and PRG Products upper control arms.

REAR: Bilstein 5125 shocks and custom full leaf spring pack by Alcan Springs.


ARMOR:
Shrockworks front winch bumper
Kennesaw Mountain Accessories rear bumper
Shrockworks sliders
Shrockworks full skid plate set including rear differential armor.

ELECTRICAL:
Pro-Comp Super HDX orbital battery
KC SlimLites mounted on bumper
Piaa 540's mounted on roof rack
KC 26 series lights mounted on roof rack (reverse lights)

Garmin GPSMAP 60CSx

RECOVERY:
T-MAX EW-10000W winch
Viking synthetic winchline (Combo line) with safety thimble
Recovery bag including Arb snatchblock, 20' rockline, treesaver, 30K tow strap, power inverter and Craftman air compressor.
48" Hi-Lift mounted to roof basket or bed

OTHER:
Truxedo Tuxport tonneau cover
Defender roof rack
16X8 Procomp 7089's
Adventure Trailer jerry can holders (bed mounted)
Wedco fuel cans
Sceptre water cans

 

my sig, if you can read it though...

 

add Titan Master cylinder to the mods:fantastic:

 

Existing list below. Hopefully sooner than later I will get to doing the SAS then the list can get longer again...

Drivetrain

* Dunlop Radial Rover R/T LT265/75R16 (31.5"x10.50")
* Transmission and T-case from a 2001 Xterra
* Calmini Rockcrawler 3.92:1 T-case gearset
* Custom 3.5" one-piece rear driveshaft
* Spicer Life-series 1310 u-joints
* 31-spline axleshaft assemblies from a 1999 V6 Frontier
* Detroit No-Spin Locker in rear axle
* Front driveshaft from a 1991 V6 Hardbody Pickup
* Front diff (4.625:1), CVs, and knuckles from a 1999 V6 Frontier
* Clutch-type LSD in front axle from 1987 300ZX Turbo
* Nissan manual hubs from a 1998 XE Frontier
* Spencer Low Racing front diff lowering kit
* Fram Sure-Drain oilpan drain plug


Suspension/Steering/Brakes

* Automotive Customizers Upper Control Arms
* Alcan Spring custom rear leaf packs
* Teraflex Revoler Shackles for an Xterra
* Rancho 5188 front shocks
* Rancho 5112 rear shocks
* Calmini HD Steering system
* Automotive Customizers Steering Stabilizer
* Automotive Customizers Extended SS Brake Lines
* Custom Rear 3/4" Bumpstop Extensions
* ABS Cancelling Circuit w/Switch on Dash
* PowerSlot Slotted Front Brake Rotors
* Bendix Ceramic Brake Pads

Interior

* Lotek 2-gauge pod replacement A-pillar
* Autometer Ultralite 2 1/16" 0-100psi oil pressure gauge
* Autometer Ultralite 2 1/16" 0-30 in. vacuum gauge
* Maglite 2-D cell with mounting clips under passenger seat
* Toyota ECT switch wired as a clutch interlock bypass
* Nissan 4wd floor shifter console and boots
* Nissan leather wrapped T-case shifter
* Pioneer 6-1/2" 2-way door speakers
* Husky floor liners Front and Rear
* Nissan neoprene seat covers
* Rewired map lights to work with dome light circuit
* Kiddie 10lb Fire Extinguisher on side wall behind seat
* Midland CB and glass-mount antenna


Exterior

* Aluminum mesh grille and bumper inserts
* Shockworks rock sliders
* MadFab undercarriage skidplate
* Front tow hooks (2)
* Draw-Tite 2" receiver hitch
* Receiver D-ring shackle
* Hoppy "TAP" trailer wiring kit
* 2003 Xterra SE 4-spoke charcoal wheels
* Pace-Edwards Roll-Top Tonneau Cover
* Custom in-bed bike rack
* Added rubber flaps to splashguards
* Vinyl letter inserts on tailgate
* '70s Jeep Cherokee 4Wheel-Drive emblem
* 2002-2004 Style Nissan hood emblem

 

Mods

Hey guys.CAI,Exhaust,Calmini level kit,8000khids,Loud *** air horn at 200psi with 3 gallon tank,10 tv and dvd set up.Just added unichip today its raining so dont wanna test too much but seems to have better throttle response and a few ponies.But need to play with it a little more ill let you guys know how it goes

 

Alright here we go....

2000 desert runner kc
calmini uca's
calmini shackles
a/c single aal
rancho 5000s all around
a/c idler arm brace
31" bfg a/t
flowmaster 50 suv with new y pipe
k&n cai
wrp grounding kit
ngk plugs and wires
complete audio system
tint
avs ventshades
silverstars


the list will grow.........i promise :duh:

 

See sig

 

2008 etx cab SE 2wd. only had it 2 weeks.
1) chrome mirror covers
2) crome tailgate trim
3) chrome doorhandles
4) chrome trim going around bottom ( not sure if i like it)
5) 20'' wheels w/ 265/50r20 tires
6) 15% tint over factory 15% on rear, 15 on sides
7) system is in progress

 

Front
Total Chaos LT Kit
FOA 8'' C/Os
PRP straps
13'' Travel

Rear
Deaver Springs
Total Chaos Shackles
14'' King Prerunner Series
16'' Travel

Hannemann Front Glass

Cage front to rear
Beard Seats
PRP 5 point Belts
Lowrance 540c GPS
Mobile Radio Race Radio
PRP Tool Bags
PCI First Aid kit

32x11.5x15 Goodyear Wrangler M/T
15'' Pro comp black wheels (simulated beadlock)

4 pro comp slim 55w lights on front bumper
4 Hella 4000 100w light on light bar

 

A bunch of stuff :tongue2:

Forgot a new picture

 

here are couple pix