Cool stuff! You should start a build thread.

 

Good call.......maybe I will start one of those.

 

How does your tonno fit? Is there a gap between the gasket and the rim of the bed at the rear? I have one with my Extang. Kind of disappointed about it, but the pressure to hold it down is like 6 inches away from the corner.

 

Looks good! What kind and % tint is that and does it match on all angles for the most part? Would like to get tint soon before summer gets here, if possible, but only want to do it once; don't want it too dark, but not too light either and more importantly provide good temp protection so to speak.

 

I believe this one is very similar to the Extang. Based on reviews at Autoanything it seemed that most people were happy with this one and that it was over $100 cheaper than Extang. There does seem to be a slight gap at the rear based on where the clamps are located to hold it down. I am hoping the rear will settle slightly after it has set on the truck for a little while.



Wish I could tell you the exact %, but I didn't ask. I've been to the same place for my last 4 vehicles. I just said to match the front with the back and I cannot notice much of a difference from any angles. They definitely did a great job.

 

Hmm. I've had mine for a few weeks now and there hasn't been a change. I wonder if there is a slight curve to the bed rail.

I had an extang two trucks ago and I was really happy with it. It was their Tuff Tonno model. The thing I hated about it was that it shrunk so much in the cold. I figured this 3 panel version would eliminate that. We will see!