Is there a chip and/or available defeat for the Auto Start/Stop. I know, "press the on/off button". I would prefer to shut it off permanently. I did read through TxDayTraders post, not sure it would work for a 2025.
rcbarr.personal
it's the exact same for the 2023.5-2025.
There are several companies selling them:
zicmoto.com
www.4dtech.com
There are several companies selling them:
Auto Stop Start Eliminator 2022-2024 Nissan Frontier
Auto Stop Start Eliminator for 2022-2024 Nissan Frontier - Made in USA
zicmoto.com
Frontier (22-24') Start / Stop Eliminator
In stock Nissan Frontier Start / Stop Eliminator, Same Day Free Shipping, 30 Day Returns, One Year Warranty
www.4dtech.com
this one specifically says it works with a 2025 (the photo looks exactly like their 2022-24 one though, not sure there is any difference at all). i like this one because no splicing, fuse taps, etc.
Those are kinda pricey. if i just wanted to do an A S S delete, i would go with the cut-off zip tie wedged in the button. Cost less than .02 cents.
I just did the 4D tech module on my 2025. The hardest part is unclipping your trim pieces. Taking my time and it took about 15-20 minutes. The small wire harness looks factory and clips in line behind the 12v cigarette lighter for power and the other end clips in line behind the A.S.S. switch. You can enable the feature again by just pressing the button though I can't imagine why you'd want to.
The whole thing is plug and play, no messing with cutting into factory wires.
It basically remembers your last selection.
The whole thing is plug and play, no messing with cutting into factory wires.
It basically remembers your last selection.
I installed a jumper wire while I had my dash apart for the stereo upgrade. Hasn't come back on since and didn't cost me anything as I already had the wire. I don't think my brain would let me do the zip tie thing, knowing there was a cut off piece of zip tie that I could likely see wedged in there would bother me to no end.
This is my 1st mod!!!! Used the zip tie. Perfect now. The button is small & low on the dash on the 25. I can't even notice the zip tie head.
You can wedge the button to keep it turned off by using an old gift card or zip tie. I made a quick 3D print to keep it all discrete and it's hardly noticeable. This mod is a lot easier and cheaper to do than taking off your dash and wire in an eliminator.
![Image]()
Do not know how true this is but someone on Reddit said they took their truck to the Dealership and they hooked it up and disabled the A.S.S and it only took a few minutes.
Thanks!!! My friend printed it for me. The 25 button is a little smaller. I had to cut a little to get it to fit. My friend will edit the print & decrease it a little to fit the 25 button.
![Image]()
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
