Nissan Frontier Forum banner

Xentec Bi Zenon HID High Low not switching

12461 Views 11 Replies 7 Participants Last post by  frontierfreak7
I just put in my HID conversion and the lights look great, except when I go to put on the high beam the light does not change. The packing slip and the box says "9007 bi xenon" I noticed that when I put in the HID bulbs that the are spring loaded and can be pushed into the socket about 1/2 inch. I am assuming that this is how the high beam in that correct? I hooked up a relay harness. The HID bulbs had a 3rd wire which I connected to the wiring harness's high/low switching lead. Any ideas on why this is not working and if I am correct on the method of the high low mechanism. THanks!
1 - 2 of 12 Posts
I have a "china brand" HID Bi-xenon kit that I bought from a local dealer. I had the same problems that you had, but i read on the forum that there are three wires on the connector on the HID kit that plugs into the stock harness that need to be switched around. All you need to do is to poke them out using a small screwdriver like the 1 for eyeglasses. I had to try about 3 times to get the right combo but i eventually got the high beams to work.

Edit: I have the "9007 Xentec 6000k Bi-Xenon HID kit"
Yes these certainly need to be hooked up right. When I installed mine, I had the Hi/Lo wires reversed which gave me Hi when my control stalk was on the Lo setting and vice versa. All it took was a simple switch of the wires and everything worked. It doesn't make sense though because that's different then the OP's problem. Unless he connected the Hi wire from the HID kit into another port then the Lo one on the stock harness.
x2 thank you for the better explanation lol
1 - 2 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.