Nissan Frontier Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,046 Posts
Ok, you've tried bending the line and it didn't work out. So now go get another line. Do not use a tubing bender. Lines are designed so you can bend them by hand. Remove the old line and bend the new one so you can connect it back up to your starting point. Then take your time, go slow and gently bend the line so it is close. It doesn't have to look perfect to work. Try to get them close wear the clamps go so it will stay put. It may seem daunting but I think you can handle it. If a nicer looking/fitting line is wanted, you can take that one off and use it as a template. Once the new line is bent you'll need to tweak it to get it on. Then when your talking about it, you can just say, eh no biggy!
Just be patient and it'll work out.
Good luck
 
1 - 1 of 1 Posts
Top