Nissan Frontier Forum banner

Titan Swap Shock Question

629 Views 1 Reply 2 Participants Last post by  glamisdude
So I did my T-Swap last week and got my alignment done. With the swap, I kept my Bilstein and OEM coil spring set up, but every now and then there is a clunk when I go over a large bump. The only thing I can contribute it to is the lower shock mount. Has anyone put bushings or washers between the lower shock point and the mount bracket on the LCA? And if so, where did you get them? I thought about some OEM washers, but wasn't sure.
1 - 1 of 2 Posts
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.