[quadracer200]

Ok, maybe I'm freaking out.....maybe not, but I need some feedback. Here's the deal: I did the gauge cluster LED swap on my 2010 fronty and when I put the needles back on I put everything back where it was when I took it apart.....HOWEVER, the next time I filled up the truck the fuel gauge went up past the last tick (full indication). It was between the bold "full" tick and the letter "F" on the gauge. Now, I coulda sworn that when I got the truck I remember that when I filled it up the needle stopped cleanly on the "full" tick.....maybe I'm wrong, I don't know. Can you guys give me some feedback on where your fuel gauge needle rests with a full tank? I'm getting down there towards about 1/4 tank but the suspense is killing me....I need to know if I screwed it up or I'm just crazy.....let me know. Thanks!

 

[wolfman437]

On my 08 when my tank is full its between the full line and the F. Its been like that since i picked it up from the dealer with 12 miles on her. Sounds normal to me. Most cars are like that as well.

 

[quadracer200]

Thanks bro! I'm feeling a little better now. We'll see for sure when I get to "E". I plan on running it 'till the fuel low light comes on for this tank. I'll be sure to post back when I get the results. Cheers!

 

[wolfman437]

fer sure. I kno the light should come on right as the needle his the red line. Thats atleast where the light come on in my truck.

 

[959frontier]

Mines is above the full line too by about quarter inch maybe. BUt then again i disassembled that thing like four times. If anything, just use your empty line as your "Oh crap I gotta put gas NOW!" line instead of going below it! Or just take off the clear plastic and set the needle a bit lower.