Nissan Frontier Forum banner

Stripped strut mount bolts! Need advice.

3942 Views 3 Replies 3 Participants Last post by  Gnarcissist
So I was installing a 2" spacer lift yesterday on my 05 4x4 fronty. The passenger side went in fairly painlessly, except for breaking 2 sockets on a stuck bolt.:-x
The drivers side was a different story. First I couldn't get the sway bar end-link nut off without spinning the bolt, but he real problem is the three upper strut mount bolts. I was using a breaker bar, and two of them stripped making the nut rounded, and when trying to get the third off, I found it was spinning the stud with the nut.

Any suggestions as to how to get the three nuts loosened? And if I can't get them off or have to cut them off, would I be able to replace the studs, or buy a whole new strut? I'm kind of at a loss, and as it is now, the truck is 2 inches higher on the passengers side. Looks pretty goofy.

Any help is much appreciated.
1 - 1 of 4 Posts
First off are you using 6 point sockets? If you were using 12 points (which tends to round stuck nuts) you might be able to still get the rounded nuts off with a 6 pt.

Not much you can do about the spinning stud. If you can some how get a U-joint swivel and a impact on the nut you might be able to zip it off. Might try lube. Tap with hammer. Heat? Other wise you are going to have to cut/grind the nut.

Good thing is that the studs are wheel stud type. They press in and out of the top hat easily.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top