Nissan Frontier Forum banner

Steel bumper and spring rates

3481 Views 10 Replies 5 Participants Last post by  TruckIt
I purchased a set of Radflo coilovers for my 2014 P4X a few months ago but haven't installed them yet. At the time I wasn't planning on getting an aftermarket bumper so I went with the 600lb springs. Now I want to get a steel front bumper and most likely a winch down the road. The Shrock bumper and radiator skid plate weighs around 155lbs. Greg at PRG said he would swap out the springs on them for me for no charge. Which ones should I go with? 650? 700? I'm also running P&P sliders.
  • Like
Reactions: 1
1 - 1 of 11 Posts
I would go 700, especially if you have steel winch cable, and double especially if you remove the sway bar
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.