Nissan Frontier Forum banner
Cancel

SPC UCA help needed

1402 Views 3 Replies 2 Participants Last post by  Shepherd40, 
Shepherd40
So I'm in the process of installing my Radflo coilovers and SPC UCAs. I have the castle nut tightened to the 45lb/ft it specifies, but there's a gap between the knuckle and the boot. Is this normal for this component? Thanks.
Reply
Save
Like
1 - 1 of 4 Posts
OutFrontFrontier
Hey Shepherd, welcome to the tribe, I grew up in the Kirkland/Kingsgate area. Were you able to find a bargain on the SPC UCAs? Getting close to pulling trigger on some but cost is king..
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Frontier Forum
Welcome to our Nissan Frontier Forum! A premier community to share your mods and builds. Chat with like-minded Frontier owners.
Full Forum Listing
Explore Our Forums
General Discussion New Member Introductions 1st Gen Hangout 2nd Gen - Exterior 2nd Gen - Suspension
Top