Nissan Frontier Forum banner

Scan

2030 Views 7 Replies 3 Participants Last post by  massbaster
So I got a Scangauge as a present and I am super pumped, it is frickin sweet. I open it up and plug it in and the first thing I do is scan for codes and guess what comes up... the stupid knock sensor code. Damn :comphead:
1 - 3 of 8 Posts
It's not a bad thing but when you get the KS fixed it will be fun-er to drive.
Unless the timing is different for the SC than on the regular v6 the range is 10 + or - 2 degrees. So I think you are good with that timing.

With a bad KS the timing should not advance. However, I have never driven the truck with scangauge hooked up so I am not sure.

On that scanguage can clear the Throttle Position Sensor Menory? When it gets warmer I want to adjust TPS as I moved it way back when and the memory needs to be cleared when you reposition it.
dont ignore that knock sensor as i did for too long.
it will start to cause issues with your cats and your o2 sensors.

i have been chasing "ghost codes" for a couple months due to ignoring the relocation project.

get that done asap.

also, i have a new location for the k\s that works as well as a place where you can get it for about 50$.

send me a private email
Please just tell us where? A lot of guys with KS issues.
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top