Joined
·
277 Posts
Ok so in the next few months I'm looking to complete my titan swap on my frontier. Soo I just got a question with this.
Anybody figure out what to do to make the rear suspension kinda match with the front. Like I'm going to get 7-10 inches with the titan swap I'm doing with the tundra 1st Gen coilovers I'm doing but I don't want to have 7-10 inches in the front to and not have anything in the rear. I want it to lean a little but I want to be able to run 20 inch rims and 33 inch tires. Any ideas as to what could kinda squat it a little bit so it looks good bit would clear 20s n 33s? Any info helps and if you have done the coil bucket tundra coilovers that gets the 7-10 inches of lift in the front post pictures below I'd like to see how it looks thanks
Anybody figure out what to do to make the rear suspension kinda match with the front. Like I'm going to get 7-10 inches with the titan swap I'm doing with the tundra 1st Gen coilovers I'm doing but I don't want to have 7-10 inches in the front to and not have anything in the rear. I want it to lean a little but I want to be able to run 20 inch rims and 33 inch tires. Any ideas as to what could kinda squat it a little bit so it looks good bit would clear 20s n 33s? Any info helps and if you have done the coil bucket tundra coilovers that gets the 7-10 inches of lift in the front post pictures below I'd like to see how it looks thanks
