Nissan Frontier Forum banner

Question for Titan-swappers

4110 Views 9 Replies 5 Participants Last post by  TWX
I'm still mulling over what I want to do to my Frontier. A full Titan swap is off the table, but I am admittedly annoyed with the bolt-pattern change for the wheels compared to the D21/D22 trucks, plus the reduced aftermarket support for the hubs with the 6 on 4.5" wheel stud pattern. The Titan and the other bigger F-alpha platforms continue to use 6 on 5.5", but the hubs don't just interchange, the Frontier uses an offset four-bolt pattern to attach the hub to the steering knuckle while the Titan uses a three-bolt pattern.

That got me wondering about the steering knuckles themselves. Have any of you Titan swappers compared the Frontier steering knuckles with the Titan steering knuckles? I'm curious if they continue to use roughly the same distance between the balljoint studs, if the steering link attachment is in the same place, and if the hub center hole is roughly in the same place, such that one could swap bolt-patterns by swapping steering knuckles without having to swap control arms. That would allow the wheels to remain tucked-under the truck in the wheel wells, but would offer a much greater selection of wheels and possibly things like manual locking front hubs.

1 - 2 of 10 Posts
Call Brandon at BTF Fabrication.
He can probably have front axles made to fit Titan hubs.
(909) 702-7462
I don’t think they did either.
They put the same wheels back on that they took off.
Not sure why you would want to?
You would then have two different lug patterns.
I can see doing it if you went to a Titan m226.
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.