[HALE]

went to the high nv desert with the guys for three days over the weekend. there was snow on the ground friday morning that all melted by noon which made for lots of sloppy mud and puddles. got stuck down in a gulley at one point. over all fun trip. now my abs and slip lights are on. I'm assuming I fouled up a sensor or two and should wash out and reset. where are the appropriate sensors if this is the case. any help is appreciated. the truck runs sounds and feels fine and did great all weekend. thanks

 

[dubie2003]

Check your ABS sensors front and rear. You probably tore one of them up or in best case, just pulled it out a bit.

 

[mike]

what....no pic's?

 

[nismo5]

^^^^x2 wheres the pics

 

[HALE]

^^^^x2 wheres the pics

charged up the camera, threw in the glove box and never pulled it out. My buddy might have some video of us finally getting out of the gully I'll ask. We had lots of guys from church come up the next day so we spent all our time setting up a four wheel drive scavenger hunt and a rifle/clay range.

 

[HALE]

can anyone be more specific on the sensors. I had a chance to take a quick look at the truck today and traced all the lines. they seem intact and all the harnesses are good. at first quick glance looks like to really check out the sensors i need to yank the wheels and rotors?? what should i be looking for, cracked?, gummed up, dubie said pulled out?? any help is appreciated. I'm a carpenter not a mechanic and trouble shooting is not in my skill set. thanks. also i should see my buddy tomorrow and i'll see what pics he got.

 

[mike]

You can ohm out all the sensors to see if their is an open in the circuit.

 

[bigdog]

there is one bolt on the back side of each hub that hold the sensor in place. If you unbolt that you can pull it right out. no need to remove wheels or hubs to get to them.