I think the part you're referring to is on this page: http://www.courtesyparts.com/fronti...rontroof-floor/680-instrument-panel-pad-cluster-lid/-c-4888_4889_5002_5015.html
Part #:68475M
But I'm not positive.
Here is the link to the actual part: http://www.courtesyparts.com/68475m-pocket-deck-frontier-d40-2005-2010-p-213745.html
They only list it as for through 2010 though so I don't know if that will fit a 2013 even if it is the right part.

Sent from my SCH-I535

 

That is the only piece that makes sense. The only other place I could see that is if there was a model offered with a single DIN stereo and that piece went below it. If the opening is just a DIN sized opening I probably have something that will fit though. I may go ahead and order it and see.

 

IIRC I think they made a change to the lower C Lid (where the cubby hole is) when they changed the Upper C Lid with the radio and HVAC controls in order to snap together properly.

 

Think you are right Kpate, but the S has the old school set up like the early models

 

OK, I really hope this part will work with the S, having the circle for the 4 wheel drive selector, 1 switch and 3 blanks just bugs the hell out of me each time I look down there. I can use this plate on my X and have a place for the switches I will likely add in the future, but the Frontier will never have anything there.

That being said, is the wiring for the traction control button long enough to put beside the non existent mirror adjustment switch or do you need to extend the wires?

 

you would likely need to extend the wires. if they are long enough, they are wrapped in wire loom as part of the wiring harness assembly.

 

I am planning on extending the wires but maybe I'll get lucky.

 

Just to close it out, this is not the part you need. This is a single din sized pocket. The opening is slightly larger.

 

Really late to the party but my cubby has "T-10664" molded in the plastic above "Nissan" and below that it says "PP-TD20". This was off of a 2005 LE 2WD. I have since replaced it with the panel that holds the 4WD switch and 4 switches.

here is a link to the compartment that holds the full size cubby you are looking for:
http://www.clubfrontier.org/forums/f114/new-lower-lid-cluster-part-68245-zp01c-graphite-89217/