X2 on the photos. Got one sitting in my garage right now waiting to be installed. I'm a visual learner when it comes to this stuff, and the pics folks post here are always more revealing than the sometimes less than stellar ones typically included with the instructions.
Impact Sensor OEM for 2010 installed
Just wanted to say I successfully installed the stock Nissan impact sensor on my 2010 SE Crew 4X4. The part number is 999M2-VU000. Works fine. Comes with the wires taps and takes about 30 minutes helped by the excellent clearance under the dash of the Frontier to the wire harness block.
One thing strange was that the Nissan instruction schematics had one of the harnesses upside down compared to what was in my truck. Just look for the correct colored wires as these are correct regardless of being reversed on the drawing. Not sure if previous models are like this or this is just a schematic drawing error someone missed before publishing. I assume it is a simply schematic mistake.
Hopes this helps someone!
One thing strange was that the Nissan instruction schematics had one of the harnesses upside down compared to what was in my truck. Just look for the correct colored wires as these are correct regardless of being reversed on the drawing. Not sure if previous models are like this or this is just a schematic drawing error someone missed before publishing. I assume it is a simply schematic mistake.
Hopes this helps someone!
1 - 1 of 8 Posts
1 - 1 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Frontier Forum
Welcome to our Nissan Frontier Forum! A premier community to share your mods and builds. Chat with like-minded Frontier owners.
Full Forum Listing
Top Contributors this Month
View All
GreyFox
296 Replies
Grumpy Shihtzu
267 Replies
NRAJOE
207 Replies
Recommended Communities
