Nissan Frontier Forum banner
1 - 8 of 29 Posts

· Registered
Joined
·
219 Posts
just saw this on pacesetters website. it says its only for manual transmission. They are the same product codes as the ones on summit.

Frontier, 2WD, 5-spd 98-00 2.4L 1-1/2" 2-1/2" 1, 3, 6 G7288 70-1196 72C1196

Frontier, 4WD, 5-spd 98-00 2.4L 1-1/2" 2-1/2" 1, 3, 6 G7288 70-1199 72C1199
Pacesetter Performance Products - Exhaust Parts for Trucks and Cars

Then again on summit, it has this:

Standard Transmission Column Shift No
Standard Transmission Floor Shift Yes
Automatic Transmission Column Shift Yes
Automatic Transmission Floor Shift Yes
 

· Registered
Joined
·
219 Posts
check this out guys this guy put on the pacesetters on his auto and he said he only had a few problems.

1-EGR tube was about 3 inches short from the header
2-flange that bolts to the cat was about 3 inches too short

He also said that you WILL have to weld in an o2 sensor bung, because the downpipe for the manual trans header doesn't have a bung, and the auto trans has it right by the flange. the link to the thread is linked below and theres his picture. Do you guys think that a exhaust shop could that care of those problems after we got it on there?

Pacesetter header installed 2.4 - Performance Tips & Tricks - Nissan Truck Forums - TUNFS: The Ultimate Nissan Frontier Site - Message Board Yuku

 
1 - 8 of 29 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top