Nissan Frontier Forum banner
1 - 1 of 1 Posts

637 Posts
Discussion Starter · #1 ·
I am thinking of upgrading my struts/springs to Bilstein adjustables and OME coils. I believe I need some of the hardware from my stock strut assembly and will need to disassemble them.

I have the standard style spring compressor and have done quite a few vehicles, however mostly cars (acura's and honda's)

Only truck strut I have done was on my 2000 Pathfinder which I replaced the stock springs with OME ones.

Any opinions on me disassembling and reassembling?

Oh, and the bilsteins would most likely be set at 1".
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.