Nissan Frontier Forum banner

1 - 20 of 27 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
HI i got a diamond plate tool box i paid $250 for it at autozone i only had it on my truck for a month i want $150 obo no shipping pick up only im in NEW YORK
 

·
Registered
Joined
·
240 Posts
first or second gen?
 

·
Registered
Joined
·
1,514 Posts
So did you get a Frontier or are you just here to sell your sh*t?
 

·
Registered
Joined
·
23 Posts
Discussion Starter #11
OK ill try this again when i bought the box i went to autozone and ask them for a tool box that fits a nissan frontier or a toyota tacoma because the company that i work for told me im going to get one or the othere so thats how i got the box.
 

·
Registered
Joined
·
8,525 Posts
Well, lets make this a little more simple. Can you post the dimensions of the box so that a potential buyer can actually see if it will fit before they even try to buy the box.
 

·
Registered
Joined
·
8,525 Posts
I followed the link and there was no dimensions shown. I am also wondering if this box would clear the wheel wells on the CC models. KCs should be alright but CCs may have issues.
 

·
Registered
Joined
·
8,525 Posts
I'd assume most would need the total width and then the "ledge" width (section that rests on bed rails). The total depth of the box so we know how far it will sit from the cab. Then lastly the overall height and then the height from the ledge to the bottom of the box so we could see if it would fit over the wheel wells or not.
 
1 - 20 of 27 Posts
Top