Nissan Frontier Forum banner

Dual USB & volt meter

5984 Views 24 Replies 9 Participants Last post by  jan
SO, I have a base CC frontier short bed 6spd. As we all know, USB ports are charging everything these days. I took it upon myself to add a dual port charger in my truck. This is for the guys with a blank above their charging port/cigarette lighter. The gray circle blank pops out,seen below.

I opened my glove box all the way, slid my hand behind that blank and it poped right out.

The white wire is +positive from the cig lighter, which I connect to the red wire from the USB charger. The black is -negative, which I connect to the black wire of the USB charger. Simple to wire up and gets you a slick addition. The link below is where I got the USB charger. I found it was what I wanted and not expensive $9. What I did was just remove the USB from the plate, which is held on by a simple nut.

12V 24V Car Motorcycle LED Dual USB Charger Cigarette Lighter Socket Voltmeter | eBay
I slipped the wires through the hole first, then connected them to the existing cig lighter port. Pushed this USB/Volt meter in, and its so tight it doesnt move. Then I just put the cig lighter back in. Here is a pic of the USB/Volt meter unit

You can see the holes in the rear of the picture where this will fit. It is a direct fit, and is tight.

Finished and slipped in.

Looking at this, I realize its a very brief writeup, so If there are questions feel free to ask. The blank is where the aux input goes with trucks that have the higher line head units. This for me worked out better than I had hoped. With more than 1 person in my car often, this makes charging easy for us all. I may do one in the rear seat further down the road.
See less See more
1 - 5 of 25 Posts
Does one take the glove box off, because I've tried to reach behind in my 2015 and I'm not finding?
This did not work for my frontier. There were no wires in behind the sockets and the unit I got did not screw into the spot or even come close to fitting.


See less See more
Yeah. The black wrapped wires are the lower power unit.

Did you splice into the wires or how did you get the power tapped?

Are you able to use both power ports at the same time without blowing a fuse?
I got it. The wires were pretty easy to cut into and supply power the the new socket. I got the dual USB into the spot it took a little force but it fit just fine.
How bright is the voltage display at night? Not distracting?

I drove it this morning into work at 430am. Its not overly bright and it sits far enough away that I dont notice it at all. Plus I have two USB items plugged into it so the Volt meter is kinda hard to see.

I'm not very good at wiring and stuff so a coworker helped me with it. The wires to the factory socket are kinda short so you might want longer jumpers. And I'm pretty sure the power draw while using both wont be an issue.

And it looks good and kinda OEM.
1 - 5 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.