Nissan Frontier Forum banner
1 - 1 of 1 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
I have a nissan navara 1989 2wd that just had a engine from a VT commodore V6 together with its matching auto installed.
I need to source if I can a ring and pinion thats equiv to 3.375 ratio.I need to lower the revs of the motor.I have a c200 diff thats running a 4.1 ratio hence the reason its reving to hard.
I believe a c200 diff in the USA came out in a Frontier with the ratio I am sourcing.If I cant get one then perhaps a complete diff change might be an alternative but which one I do not know.I would like to source one in Australia because it would be cheaper to ship.
Any IDEAS anybody?

Regards Andrew
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.