CJD Racing

3619 Views 4 Replies 3 Participants Last post by EastCoastSV, Nov 8, 2017

EastCoastSV

Discussion Starter · Nov 8, 2017

Anyone here have experience dealing with CJD racing? They seem to be less well known than PRG and Nisstec but make some pretty beefy control arms. I was thinking about going with their titan tube uppers and he says he can get T swap radflos just like Greg and Chris. Wanted to know if anyone is running their products or purchased from them?

Sent from my iPhone using Tapatalk

Save

1 - 3 of 5 Posts

EastCoastSV

Discussion Starter · #3 · Nov 8, 2017

The other Sean said:
While I have no experience with them, keep in mind any control arm with Uniballs or heim joints will have a reduced life in environments with any kind of harsh winter environment as compared to a standard sealed ball joint or bushing. That's why I went with the SPC Uppers.

I live in Oklahoma and run heim UCA’s right now. I️ prefer the design and haven’t noticed hardly any wear. If I were to go SPC it would only be to save money i think.

Sent from my iPhone using Tapatalk

Save

EastCoastSV

Discussion Starter · #5 · Nov 8, 2017

Nomad 13 said:
Great guys and they make some awesome components. I've installed several sets of their CJD uppers on both stock width and swapped frontys and Xs. They are a little bit heavier than the PRG UCAs but the build quality is top notch and their cust service is excellent.

Thanks for the input, beefier and a tad bit cheaper than PRG, plus I was actually able to get ahold of them which was nice. He can’t get the 2.0 TS radflos so I may still have to get those from PRG or Nisstec but I’m looking forward to installing these arms.

Sent from my iPhone using Tapatalk

Save

1 - 3 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month