Nissan Frontier Forum banner

Changing catalytic converts my self

15278 Views 7 Replies 8 Participants Last post by  ef9
Anyone already did this and can give me some advice on how to do it? I'm pretty good at working on my truck. (Done a lot harder than this) but on the two front converts it almost looks impossible to undo the bolts on the engine side because the heat shield is in the way. But at the same time it looks crazy hard to try and get that heat shield off. It's hard enough to even see the bolts on the thing. Any advice on how yall did it would help! Thanks (2005 frontier 4.0)
1 - 1 of 8 Posts
The very last thing op stated was (2005 frontier 4.0).
So yes he has a v6.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top