Yep, I used to run a Steelcraft on my rig before I replaced it. I will say that the shop had to do some fab work to build a spacer for it on my '13 Pro-4X due to it not sitting right. I should have shots up on my build page (see sig). The Steelcraft held up well all said and done. Got put through its paces, drilled it to hold a 30" light bar up front (instead of the pre-drilled holes) and it didn't give me rust issues at all. Also, even though I went through about 2 windshields from multiple rock impacts (the roads down here are terrible for it) the powder coating held up remarkably well and I sold it off for a cool $100 to another Fronty owner down here after using it for a couple good years.
Anyone have any experience with these?
Ive been wanting to get some grille guards for my 2016 CC, and Ive looked around at a lot of different types. There was a specific look I'm going for, and based on that, plus cost, I found this one. Its a Steelcraft 54090. Just curious if anyone has any experience with this particular brand or even specific model. Just want to get a few opinions before going ahead and spending the money. One particular thing that also drew me to this one is that they make a set of taillight guards that would work for the back, and I can be a little OCD when it comes to things like that. But it's not set in stone...
![]()
1 - 1 of 4 Posts
1 - 1 of 4 Posts
