Nissan Frontier Forum banner
Cancel

ACC Source For Distribution Block

2649 Views 5 Replies 3 Participants Last post by  mtyler11, 
A
I'm am planning to wire a ACC distribution block in my frontier and have a question.

My plan is to run a 12 gauge wire with 30 amp fuse. Fuse tapped into one of the ACC fuse located by the passenger side.

My question is will the thin gauge factory wire of the ACC source support up to 4 ACC input? I will be mainly powering my backup camera, radar detector, iDatalink Maestro and rear view mirror.

Thanks in advance.
Reply
Save
Like
1 - 2 of 6 Posts
The other Sean
Run the power straight from the battery and switch it with a relay. That way you are only pulling a small amount of amperage off the OEM wiring.
Reply
Save
Like
The other Sean
Google is going to be your friend. If you can find links where they post pictures and or photos is best. It's actually relatively simple.
Reply
Save
Like
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Frontier Forum
Welcome to our Nissan Frontier Forum! A premier community to share your mods and builds. Chat with like-minded Frontier owners.
Full Forum Listing
Explore Our Forums
General Discussion New Member Introductions 1st Gen Hangout 2nd Gen - Exterior 2nd Gen - Suspension
Top