[Berttech13]

Hi all I just did a lot of work to my 2004 nissanfrontier it has the 3.3l motor and the motor turnout great but since I had the Trans down to rebuild the motor I replaced the filter and now I'm having a hard shift going into second gear.code Po732 I think the filter did not seal right anyone else have this problem? Could it be the Trans fluid? ? I used merc 3 that what the book said was used any help and information would be great

 

[The other Sean]

Have you checked and double checked the fluid level? Are you checking the level in the correct manner which is probably engine running, trans in park?

Did you check and double check all linkages and electrical connectors are hooked up properly?

 

[Berttech13]

I dropped the Trans pan today did a visual inspection everything looks good. level was good the truck was hot in park at idling shifting and adding fluid little bit at a time until it was full test drive again it feels like the Trans is low on fluid the filter is from autozone could that be the problem.I checked all my wiring and plugs I'm sure everything is wired properly

 

[The other Sean]

When filling it back up in the driveway and topping off, did you move the shifter through each position and recheck before the initial test drive?

Did you recheck the level after driving it?

 

[Berttech13]

I recheck the leve and it was good did some looking online for that code p0732 there's a TSB by nissan that the TPS will mess up your readings to the ECM if the TPS is out of adjustment I recheck that and I had it at .50v when I rechecked it it was at .88v with in range but just at the max I adjusted the linkage and the TPS retest after rechecking Trans fluid not one code came back