Nissan Frontier Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. 3rd Gen Frontier Builds
    Winch mounting plate ready! After breaking the 500 km mark and having the dealer check for any stored codes or any sensor calibration issues, we at Traxion are proud to introduce our Frontier 2022+ Pro4x winch mounting plate. So far, we have mounted Smittybilt XRC 9,500 Comp and Warn Vr Evo 10-s...
  2. OffRoad / 4x4
    I have a Pro-4X and want to do more of what it’s actually meant to do! Of course a nice bumper is on my wish list but in the meantime can anyone suggest a way to attach front winch to the frame/ is there a mounting plate setup that could work with factory bumper? Or should I just invest in some...
  3. OffRoad / 4x4
    Hey all, just wondering if anyone has mounted a winch tray in place of the factory tow hook(s) area. Also if anyone has tabs on a tray with built in clevis mounts on the front.
  4. 2nd Gen - Exterior
    Would it be possible to have a winch and a bull bar? it looks like one would fit with the WAM frontier Winch carrier It looks like it would be long enough where it would not mess with the bull bar. Has anyone else done it or would it even work? I have a Rough Country bull bar with a led light bar
  5. 2nd Gen - Exterior
    After building my concealed front 2" receiver hitch I didn't have any front recovery points installed on the truck. I could have put the stock one back on and dealt with bolt length for the mounting hardware if it proved to be problematic, but I wanted both sides to be the same and even before...
  6. New Member Introductions
    I've got a 2019 Crew Cab SE. Other than the turning radius of the Queen Mary I really like this truck. I'm in Texas and plan on going out to the north end of South Padres island. I'm replacing the front bumper with an aluminum one being built by an FFA team to show at the San Antonio Rodeo &...
  7. General Discussion
    I’ve seen A lot of different winches out there. I just sold my Jeep for a 2005 Frontier LE. It’s got spaces so it’s lifted about 3inches. That’s the only non stock thing about it. i would like a winch since i do some off roading every now and then. No mud. Mainly gravel or dirt roads. Some...
  8. 1st Gen Hangout
    Hey all, I've found myself taking my truck down trails more often than I thought I would, and have gotten in a bind a couple times where a bumper with a winch mount would have been useful. I've found a few commercially available bumpers, but I'm curious what you've put on your truck or built...
  9. 2nd Gen - Exterior
    It was a bit of a pain to install because of the cutting and such but all in it cost $505 for the winch carrier and the radiator skid including shipping. I also cut the corners off the stock chrome bumper for more clearance. I may cut it more if I can find a suitable fog light mounting solution.
1-9 of 9 Results
Top