Nissan Frontier Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. 1st Gen Hangout
    Recently bought a whole crate motor due to lack of time to rebuild. The Crank and RH Cam gear are not in TDC. Would you loosen Rockers to relieve tension on the valves and then set Crank to TDC then set the cam gear to TDC? I'm new to working on interference motors and would rather have someone...
  2. 1st Gen Hangout
    Hey howzit, I needed to replace the HVAC blower motor resistor in my '02 and figured I'd change the cabin air filters while I'm at it. But there doesn't seem to be an easy way to remove and replace the filters: I've watched some YT videos but they all show just releasing some clips and pulling...
  3. 1st Gen Hangout
    So I managed to find a 1999 king cab frontier with basically no rust, I snapped it up and after getting home I noticed a few things that I'm not sure if its stock or not. Its late now but tomorrow I will get photos. Firstly, the door sticker claims my engine is a 6vg5, after googling that engine...
  4. a

    New Member Introductions
    A
  5. 1st Gen Hangout
    Its automatic. V6 Part 1 https://youtu.be/SjLnm0RSB9c Part 2 Remove Engine upper intake manifold. Engine rear main oil seal removal. Engine rear main oil seal installation. https://youtu.be/Z8Nbo3L4GZU Part 3 of engine hussle Part 4 of engine haul. Pre-installation saga. Nissan...
  6. 1st Gen Hangout
    Sorry to create another discussion on timing belts, I cant find an answer to this question in other posts or anywhere else on the net. Had the belt break in my 2001 frontier vg33e at 155,000 because I wasnt aware of regular maintenance and had ultimate faith in the reliability of the truck...
  7. 1st Gen Frontier Builds
    2004 Nissan frontier Xe crew cab vg33e automatic 4x4 that i have basically restored because we love it but, while in park it used to have REV LIMITER around 3500RPM you could hold foot to floor and it would just bounce off rev limiter until you let off gas peddle, Now that does not work, also...
  8. 1st Gen Hangout
    2004 Nissan frontier Xe crew cab vg33e automatic 4x4 that i have basically restored because we love it but, while in park it used to have REV LIMITER around 3500RPM you could hold foot to floor and it would just bounce off rev limiter until you let off gas peddle, Now that does not work, also...
  9. 1st Gen Hangout
    Hi I am in the process of buying a 2004 Frontier Crew Cab with the VG33E V6. I was wondering if there is anything i absolutely need to check before purchasing and if there are any major problems is should know about. I have test driven the truck and it seems mechanically sound.
1-9 of 9 Results
Top