Nissan Frontier Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 1st Gen Hangout
    I am the new owner of a 2002 supercharged crewcab, but a recent problem has me stumped. Under acceleration, the CEL flashes showing a random misfire code, and it pings/detonates aggressively. It feels like it is pulling all of its timing. I put in a brand new oem knock sensor, as well as a new...
  2. 2nd Gen - DIY - Do It Yourself / Tech Tips
    Alright after replacing the ac compressor, drier, expansion valve, and every o ring and putting in new refrigerant it worked perfectly the air blew cold, then after day 5 the ac blew less and less cold and eventually I started hearing a hissing noise coming from the passenger side glove...
  3. 2nd Gen - Lighting / Electrical / Wiring
    First of all does a 2016 2.5l even have a ac relay? I ask because my new compressor’s clutch is not engaging when I tired to recharge the system. The fuse is good next thing I went for is the relay but I couldn’t find it. Anyone know?
  4. 2nd Gen - DIY - Do It Yourself / Tech Tips
    It is time for a new ac compressor, I have been putting it off for 2 summers now and I refuse to go through another again. I got a KC 16 2.5l @100k, should I also change the filter drier and expansion valve? Should I do it for preventative maintenance? Also before I do the job I plan on getting...
  5. Wanted
    Hello a few months ago I had an accident, and I lost some parts of my truck, specifically the one that is consisting of getting is the next one, if someone could help me with some advice on how to get or as this part is called, I would be very grateful.
  6. 1st Gen Hangout
    2002 Frontier V6 - Crew cab Several months back I had the muffler replaced and was informed I had a big leak at the exhaust manifold. I do, and it is noisy. I was quoted about $450 for the repair + $80 for each bolt that needed to be re-tapped. I hooked my shop vac to my exhaust and blew air...
  7. 2nd Gen - DIY - Do It Yourself / Tech Tips
    I have a leak coming from the front crank seal on my frontier but can’t for the world figure out how to get it off. has anyone done this before? I’ve seen people who drill and tap it but it seems risky being so deep in the engine also would I need to get a new sprocket after? anyone have a way...
  8. 2nd Gen - Drivetrain Discussions
    Alright folks, Ive got a bit of a story, and a bit of a question. And I need some help from someone who knows more than me. DISCLAIMER: Ive spent the better part of a month peeling through old posts, tech reports, and rants, and havent found a clear solution, though there are quite a few posts...
1-8 of 8 Results