Nissan Frontier Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 1st Gen Hangout
    I have a 2000 Frontier RWD King Cab XE with the KA24DE 4 cylinder. At 160,000 most of the original lower timing chain guides and tensioner were in the oil pan sump. I did a full replacement with all gears, all chains, all guides, both tensioners, oil pump, water pump and now I have the same...
  2. 1st Gen Hangout
    Hello All, I am new here, I had to signup and ask because I couldn't find anything while searching. I have a 99 2.4 2wd M/T frontier that I just purchased maybe about less than a year. I've done a lot of work on it since I bought it. I am in the final stretch, and the last problem was to find...
  3. New Member Introductions
    Hello All, my name is Robert and I have a 2000 Nissan Frontier XE that I am planning on turning into a nice Shop truck with a spicy KA24DE engine. I have owned it since it was new and now (200k miles later) it is time to breath some new life into her. Thanks to all you Frontier people out there...
  4. 1st Gen Hangout
    My idle isn't to great it alternates from 800 to 500 sometimes acts like it wants to die Also said that it is lean on bank 1 too much air and idk what to do I've changed the following Spark plugs/wires Map sensor and maf sensor Knock sensor All 3 belts Gray connector on throttle position...
  5. 1st Gen Hangout
    What’s y’all experience with ITM, Cloyes, and Melling? I know theres more brands out there but needed opinions due to seeing some guys have bad experiences with the rattle, chain slap. Leaning on going with Melling due to reading reviews of longevity. Let me know y’all thoughts and opinions 🤙🏽🤙🏽
  6. 4 Banger Lounge
    My 2003, 4 cylinder ka24de manual will crank up fine, idle well, and run well while not under load (in gear). It also runs and drives fine shortly after starting. After driving for a while it will hesitate (lose power) for a second and then run again. The more I drive it the more frequently it...
  7. 1st Gen Hangout
    My 2003, 4 cylinder ka24de manual will crank up fine, idle well, and run well while not under load (in gear). It also runs and drives fine shortly after starting. After driving for a while it will hesitate (lose power) for a second and then run again. The more I drive it the more frequently it...
  8. 1st Gen Hangout
    Derp, wrong forum. Posted in project threads here: Fixing up the $350 First Gen
1-8 of 8 Results
Top