Nissan Frontier Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 2nd Gen - Drivetrain Discussions
    My 2011 SV just started a weird kind of rough idle. Similar to the rhythm of a motorcycle that has a low idle. It will try to reach its idle RPM but can’t seem to get there and then just cuts off. I also opened the hood and there seems to be a lot more heat coming out than normal but the temp...
  2. 1st Gen Hangout
    Need help please: Hello! Today I'm replacing the idle air control valve on my 01 Frontier with the VG33E non-supercharged. I rebuilt this engine about 3 years ago and for the life of me can not remember doing the idle air control valve. It has now become a major issue, (pretty sure it fried the...
  3. 2nd Gen - DIY - Do It Yourself / Tech Tips
    My 2010 frontier is intermittently clicking in idle. It also clicks again right after I turn it off. See short video of it occurring: Any help or suggestions are much appreciated. Thanks!
  4. 1st Gen Hangout
    My frontier runs rough. When I turn it in it revs high (1500rpms) then when I put it into gear it drops(500-700rpms). Sometimes it doesn't want to start. I replaced the MAF since the old one did not give me any data. Before the new MAF it was not drivable. When I put the new one it ran fine, but...
  5. 1st Gen Hangout
    Do not forget to clean inside the throttle body air(butterfly) valve with a throttle body cleaner(aerosol can). Do not run/operate engine while cleaning inside of the TB might be easier but you must consider the burning carbon may cause contamination of oxygen sensor and harm catalytic...
1-5 of 5 Results
Top