Nissan Frontier Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. 2nd Gen - DIY - Do It Yourself / Tech Tips
    Hey everyone, So I’m back with my 2010 v6 manual. I’ve been aware of a leak from the bottom coolant line for a awhile but put it off until I had time to replace it. Yesterday I found time to get it done, filled it back up, burped the system.Ran the engine for a bit to check pressure, temp, and...
  2. 1st Gen Hangout
    After having some issues cooling my truck I took it into the shop and had it looked at. All they said was that it was low on refrigerant and refilled it. I had thought that it would only run low if there was a leak and asked about it. They said they did pressure tests and it was fine and had put...
  3. 1st Gen Hangout
    Hey howzit, I needed to replace the HVAC blower motor resistor in my '02 and figured I'd change the cabin air filters while I'm at it. But there doesn't seem to be an easy way to remove and replace the filters: I've watched some YT videos but they all show just releasing some clips and pulling...
  4. 2nd Gen - Performance
    Hello All, A couple months back I was driving the 5 and noticed my temp gauge fluctuating a ton up and then back down when I stopped accelerating. I kept it at 65 and made it home fine. When and got my coolant topped off cause it was low But now the temp gauge doesn’t move AT ALL. I’ve done a...
  5. 2nd Gen - DIY - Do It Yourself / Tech Tips
    I have a 2011 equator 2wd with the 4.0. The motor was overheating so I changed out the following. Water pump, thermostat, radiator, temp sensor, fan clutch and upper and lower radiator hoses. I installed all this pulled a vacuum on the system and filled the coolant with the vacuum. Shouldn’t...
  6. 2nd Gen - DIY - Do It Yourself / Tech Tips
    I have a 2009 Frontier with the VQ40 with 271k miles and I've started to have a cooling issue where if im sitting still the temp will start to climb. While moving I have almost no issues just while im sitting still. In the past year I have replaced Thermostat, Water pump, and fan clutch and it...
  7. 1st Gen Hangout
    This was the greatest thing I have done to my D22 frontier. So many benefits* in this mod, its more than worth it for any trucks. . *Save gas *Increase water pump endurance. *Free-up Horsepower. *Reduce engine warm-up time. *Increase acceleration, quick throttle response. *Less noise, more...
1-7 of 7 Results
Top