Nissan Frontier Forum - View Profile: OutFrontFrontier
Shift_Enthusiast

OutFrontFrontier OutFrontFrontier is offline

  Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. kldubois
    12-16-2016 10:47 AM - permalink
    kldubois
    Checked coolant level, added not much but did crank engine and turned on AC. Noticed pulsing stopped when AC on but started back when AC off.
    That must be something. Did notice that there was no change in idle when turned off an on the AC. Thought there was a control to up idle when AC turned on. Your thoughts? Joe
    Mind texting me? 786 281 1220
  2. Sho_Nuff
    06-28-2016 04:29 PM - permalink
    Sho_Nuff
    i noticed you had the Yakima tracks installed on your canopy and i was wondering what width you had them installed at. i have a leer canopy as well and i don't want to drill where I'm not supposed to drill.

    I'm digging your truck by the way.

    oh yeah...GO HAWKS!
  3. OutFrontFrontier
    05-20-2015 12:28 PM - permalink
    OutFrontFrontier
    Sorry for delay, I don't pay much attention to the PM's. No CBC. But I am unhappy with the front camber \/. My next move will be some SPC upper control arms to get /\ up front. Then possibly swapping the .5 for a 1" spacer. I guess you can install longer studs so the 1" will bolt in. My new sliders make it look low again. Vicious Cycle!!!
  4. Paulny61
    05-03-2015 07:30 AM - permalink
    Paulny61
    I noticed that you have adjustable Bils set at 1.5 with a 1/2" PRG spacer. I have a 2wd with Bils at 1.5 and have been thinking about doing the same spacer. Do you get any cowl bucket contact with this set up? Also would you happen to have a picture of your Frontier that I could see?

    With my Bils Set at 1.5 I had an increase of 1.75". I also put the 5100 Bils on back with 1" block and it increased 1.5".

    Thank you!

  About Me

  • About OutFrontFrontier
    Biography
    2012 Frontier CC 4x4 SV Sport Pkg. Bone Stock exc. Gentex Mirror w/temp, compass, homelink
    Location
    Spokane, Wa
    Interests
    ATV/MC, RC Crawlers, Snowboarding
    Occupation
    Blue Collar
  • Signature

    2012 Avalanche CCSB 4x4 SV Sport Package
    What's Done- Hefty Fab Sliders, Leer Canopy, Y-pipe mod, Funky Fronty sticker peeled, Gentex Homelink mirror w/temp, Prodigy P2 brake controller, 7-pin in bumper, axle vent mod, AudioControl LC7i l.o.c./Kenwood KAC-M8005 5 ch amp/Polk DB651 x4/Pioneer TS-SW2502S4 10" sub.
    Hanoook Dynapro ATM 275/65/18,
    F. Bilstien 5100s @ 1.5" + a 1/2" PRG Spacer, Nissan Camber bolts,
    R. 1.5" PRG Blocks & Firestone Ride Rite bags #2558

    What's Next- SPC UCAs, Hefty Alum Skids ...

    20 Rigs in 20 yrs of driving! Will this be the Last???

  Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Today 06:24 AM
  • Join Date: 11-06-2013
  • Referrals: 0

  Garage

    2012 Nissan Frontier 4x4 Crew Cab Short Bed
    Charlene
    1965 Chrysler Newport
    The Good Ol Days
    19 U Name It
    The Toys

  Mentions

No results to display...

  Quotes

06-29-2017
07:22 AM - doppelganger quoted OutFrontFrontier in post Spark Plug evaluation
Seller have good feedback? 98.9%, ...
06-13-2017
02:58 AM - whistler quoted OutFrontFrontier in post ColoRADo
Shame, all that work just so it could...
04-27-2017
01:09 PM - mass-hole quoted OutFrontFrontier in post Looking at Frontiers, need some advice
Toyota, lol, I remember well maintain...
09:36 AM - mtyler11 quoted OutFrontFrontier in post Looking into new tires,whats good?
.... I would have bought ******* if t...
04-20-2017
08:57 AM - OutFrontFrontier quoted The other Sean in post Question about sliders/rockers etc
I had my Hefty sliders swung in to ...
03-08-2017
08:51 AM - OVRLND quoted OutFrontFrontier in post Lift question/camber question.
With only 2" of lift my front camber ...
02-12-2017
12:49 PM - GMK14 quoted OutFrontFrontier in post Paint chip fixes
I still get sand blasting after the i...
02-02-2017
10:36 AM - Thelt quoted OutFrontFrontier in post Truck Camping
Craft store for foam? Have a fred mey...
01-30-2017
03:01 PM - picklez quoted OutFrontFrontier in post Skid Plate Group Buy
Depend on cost but I might be in? Whe...
01-24-2017
03:21 PM - ozzyt10 quoted OutFrontFrontier in post First time Nissan owner, ready to do work on it.
Don't worry, I'm a classified section...
03:21 PM - ozzyt10 quoted OutFrontFrontier in post Deleted Posts
01-20-2017
10:55 AM - OutFrontFrontier quoted kgordon in post truck bed unloader
I would pull that out to che...
09:27 AM - kgordon quoted OutFrontFrontier in post truck bed unloader
I have the plastic Nissan Drop in bed...
01-18-2017
10:48 AM - kgordon quoted OutFrontFrontier in post truck bed unloader
That's how I do it, another benefit o...
01-16-2017
07:28 PM - OutFrontFrontier quoted LittleBull in post truck bed unloader
I have a heavy tarp from HD I l...
01-12-2017
10:13 PM - RedFox67 quoted OutFrontFrontier in post WTB: Sliders
Not sure if you've come across these?...
09:44 PM - Zedbra quoted OutFrontFrontier in post WTB: Sliders
Not sure if you've come across these?...
03:13 PM - raine quoted OutFrontFrontier in post Lift Questions
You Folks are my social media experim...
01:53 PM - raine quoted OutFrontFrontier in post Lift Questions
my stuff comes from saving my allowan...
03:00 AM - J&JPolangin quoted OutFrontFrontier in post Lift Questions
...so I got to buy them from the join...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
View Complete Feedbacks for OutFrontFrontier
  Past
Month
Past
6 Months
Past
12 Months
 Positive 0 0 0
 Neutral 0 0 0
 Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome