Nissan Frontier Forum - View Profile: invasion08
Shift_Hardcore

invasion08 invasion08 is offline

  Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. Racksaw
    07-05-2016 10:12 PM - permalink
    Racksaw
    It is not level right now, and I do not know how much settling will occur. My lowest measurement has been 36 inches from ground to center fender on front, and 37.5 inches on rear. I've read Pathung's build thread and noticed he has the same setup with 1.5 inch spacers on the front but I cannot remember reading whether or not he is level. He also has a lot more armor than I do as I have nothing else done to my truck.
  2. Racksaw
    07-04-2016 10:10 PM - permalink
    Racksaw
    I have added an album to my profile with pictures of the lift and control arms. If you have any specific questions about it let me know.
  3. Racksaw
    07-03-2016 03:09 AM - permalink
    Racksaw
    Yes, I did OME medium duty lift front and rear and SPC upper control arms. I can take pictures Monday morning after work (let me know if you would like specific items). The driver side UCA rear bolt was a pain, but I separated the steering linkage and imposed some will to get it out. I installed it from the other side so it shouldn't be a problem in the future. If you haven't bought the kit already and the option shows assembled struts for the front I would recommend them unless you have access to a shop to get them assembled. Taking them somewhere leaves you open to misaligning the coil on the shock (there is a post about OME kit installs and has a great picture that I referenced to get mine assembled to put on). The UCA setting is something of pure preference. I read the sheet that comes with it and I have mine set on setting D (I will provide a picture of this too) which gave me around one degree of positive camber.
  4. KamyKazyTommy
    12-02-2012 02:09 PM - permalink
    KamyKazyTommy
    .

  About Me

  • About invasion08
    Location
    NJ
  • Signature
    PRG Basic Suspension Package
    XTP IMS, Gibson Exhaust, Airaid Intake, UpRev Tuned, Bakflip F1 , Line X Bed Liner

  Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Yesterday 09:47 PM
  • Join Date: 04-12-2011
  • Referrals: 0

  Friends

Showing Friends 1 to 3 of 3

  Contact Info

Instant Messaging
Send an Instant Message to invasion08 Using...
This Page
http://www.clubfrontier.org/forums/members/invasion08-32475.html

  Mentions

10-13-2015
12:33 PM - HueyDude mentioned invasion08 in post What is your recommended lift body, suspension, or both?
...t to do with it. As invasion08 and kgordon said, re...

  Quotes

01-15-2017
12:26 AM - smj999smj quoted invasion08 in post 05-07 Timing Chain Class Action Lawsuit
The only person that wins in th...
01-12-2017
10:52 PM - heyitzdinny1 quoted invasion08 in post transmission filter
Yes it can be replaced. Might ...
01-08-2017
07:10 AM - teecro quoted invasion08 in post 1st and last Nissan
I find the seats in my Frontier...
07:04 AM - teecro quoted invasion08 in post 1st and last Nissan
I find the seats in my Frontier...
02:03 AM - whistler quoted invasion08 in post 1st and last Nissan
I find the seats in my Frontier...
12-23-2016
02:52 PM - NovaBeJota quoted invasion08 in post cat back exhaust
Gibson has a exhaust for the cr...
12-20-2016
02:25 AM - Arthur_C quoted invasion08 in post Why should i buy a Bullydog for my truck?
I am very happy and would do it...
12-14-2016
01:10 AM - invasion08 quoted manzellaj in post What have you done for your Frontier today/lately?
Oil change and changed the air...
12-13-2016
09:25 PM - Arthur_C quoted invasion08 in post Why should i buy a Bullydog for my truck?
I am very happy and would do it...
08:12 PM - Arthur_C quoted invasion08 in post Why should i buy a Bullydog for my truck?
The route I went with was Uprev...
12-06-2016
05:47 PM - invasion08 quoted waric in post The Ultimate VQ40 Aftermarket Exhaust/Muffler Discussion Thread
Is there a muffler that yo...
10:35 AM - Y22C quoted invasion08 in post After lurking...
Thought you were talking about ...
12-05-2016
10:11 PM - DGleason78 quoted invasion08 in post After lurking...
Thought you were talking about ...
10:05 PM - DGleason78 quoted invasion08 in post After lurking...
Temp gauge is normal. The dipst...
02:28 PM - mtyler11 quoted invasion08 in post The truth about Matic J
Adding new trans fluid to old f...
12:34 PM - invasion08 quoted mtyler11 in post The truth about Matic J
Perhaps I need to clarify... ...
10:06 AM - mtyler11 quoted invasion08 in post The truth about Matic J
The first drain and fill would ...
10:01 AM - mtyler11 quoted invasion08 in post The truth about Matic J
The first drain and fill would ...
10-31-2016
11:28 AM - Cusser quoted invasion08 in post Ugh, dented my oil pan, '99 4x4
Buy a skid plate to protect the...
10-28-2016
09:10 PM - vjmvjm quoted invasion08 in post 2017 Frontier with FFV
I have yet to see a gas station...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
1
100.0%
Members who left positive:
Members who left negative:
1
0
Total positive feedback: 1
View Complete Feedbacks for invasion08
  Past
Month
Past
6 Months
Past
12 Months
 Positive 0 0 0
 Neutral 0 0 0
 Negative 0 0 0