|
|
|
|
|||||||
| Register | Home | Forum | Gallery | Active Topics | Register | Search | Today's Posts | Mark Forums Read |
 |
|
|
LinkBack | Thread Tools | Display Modes |
07-13-2008, 07:34 PM
|
|||
|
|||
|
Front seat not sliding. HELP!
2000 Frontier 4X4. Manual front seats. I pull the lever to pull the seat forward and it just doesn't want to work. I carefully checked to see that all the latches were disengaging when I pulled the lever. They do. I then checked the operation of the passenger seat and it looks the same. I took the seat out today and the seat disengages when I pull the lever with the seat removed. Slides on the rails nicely. Once I bolt it back in it doesn't want to budge. Anybody else with this problem?
Thanks. Bob 
|
| Sponsored Links | ||
| ||
|
|
|
07-19-2008, 07:02 PM
|
|||
|
|||
|
Anyone? Anyone? Buhler? Buhler?
|
|
07-20-2008, 05:02 PM
|
|||
|
|||
|
sounds like its binding somewhere... make sure that when you put it in, nothing is in the tracks...
__________________
 see pics of the truck Here 2004 XE 2.4l I-4 part of The Lifted XE Club! F.W.O West Coast Chapter MODS: Total Chaos Long Travel Kit, Shock Hoops, Fox 2.5 coil overs w/ eitbach springs, Fiberglass Fenders, Dever progessive add a leafs, Panasonic CQ-C7303U Clarion 4 channel 400W amp pushing a set of JL audio 6.5 Compents, MA Audio 400w 2 channel amp pushing Kicker Comp 10", XM Radio, Magnaflow 2 1/4 in/out dumped before the axle. 5% tint on rear windows 35% on front windows, oval fog lights from kragen. Soon to be mods:engine brace, Future mods: Rear Deavers
|
|
07-20-2008, 06:34 PM
|
||||
|
||||
|
Mine got stuck good once. Somebody had pushed it back and one side was farther back than the other so it was kind of stuck. Make sure you seat is not like that.
__________________
 2006 SE KC 4x4 auto 
|
|
07-20-2008, 07:07 PM
|
||||
|
||||
|
Get that big fooking amp out from under there?
Seriously though, sounds like something is impeding the sliding action. You say it slid when removed from the truck, but not when bolted in the truck?
__________________
Interior Mods: Kenwood KDC-MP438U, Sirius, Polk Audio MMC6500 (front), Polk Audio DB651 (rear) Alpine PDX-5 @600 watts, Polk Audio DB104 sub w/custom fiberglass enclosure, Gentex Temp/Compass/Homelink Mirror, Weathertech floor liners front/mats rear, ScanGauge II w/blendmount. Exterior Mods: Silverstar Ultras, Hella Micro DE driving lights, EZDown Tailgate Damper, Extang Full Tilt Tonneau cover, Weathertech side window deflectors. Performance Mods: Flowmaster 50 Series dual in/dual out (PT# 524554)w/ stock dia. 2.25” pipe, Nismo CAI. Write ups: Alternate tweeter location / stereo install synopsis (PICS!) Custom fiberglass enclosure is finally FINISHED !! ToddG's upgrades/mods (with pics!)
|
|
07-21-2008, 11:44 PM
|
|||
|
|||
|
Quote:
|
|
07-22-2008, 01:09 PM
|
||||
|
||||
|
Quote:
Hmmmmm . . . . is the seat clear of all obstructions front, rear, sides and underneath?
__________________
Interior Mods: Kenwood KDC-MP438U, Sirius, Polk Audio MMC6500 (front), Polk Audio DB651 (rear) Alpine PDX-5 @600 watts, Polk Audio DB104 sub w/custom fiberglass enclosure, Gentex Temp/Compass/Homelink Mirror, Weathertech floor liners front/mats rear, ScanGauge II w/blendmount. Exterior Mods: Silverstar Ultras, Hella Micro DE driving lights, EZDown Tailgate Damper, Extang Full Tilt Tonneau cover, Weathertech side window deflectors. Performance Mods: Flowmaster 50 Series dual in/dual out (PT# 524554)w/ stock dia. 2.25” pipe, Nismo CAI. Write ups: Alternate tweeter location / stereo install synopsis (PICS!) Custom fiberglass enclosure is finally FINISHED !! ToddG's upgrades/mods (with pics!)
|
| Sponsored Links | ||
| ||
|
|
Linear Mode
