has anyone seen this lift from cst 4" with spindles

[mr_bungle]

i want to know if they have it for 4x4 and this would go good with prg stuff this might be a good alternative



http://cgi.ebay.com/ebaymotors/05-07...spagenameZWDVW

[penski61]

yeah there are quite a few guys running that setup and as far as i know they dont make it for 4wd cause of our cv's

[mr_bungle]

that stinks what's wrong with our cv's?

[bwarren228]

x2 you can't use spindles w/ 4wd. All it basically does is lower the point where the wheel/hub assembly bolt to.

[Irongrave]

You can get the CSTs form PRG 2

[mr_bungle]

but you get new spindles with the fabtech and calmini lifts and that 4x4

Originally Posted by bwarren228

x2 you can't use spindles w/ 4wd. All it basically does is lower the point where the wheel/hub assembly bolt to.

[toyniss]

Originally Posted by mr_bungle

but you get new spindles with the fabtech and calmini lifts and that 4x4

yes but spindles arent what gives u lift with 4x4 because of the front diff/cvaxles.........................
2wd the spindles allow to push down on the hub/lca to give lift.

[mr_bungle]

my bad it is not spindles they're steering knuckles

i am so confused on which lift to get i want 5 to 6" but i don't want blocks i want shackles and leafs and in front i want tc uca's and the calmini or fabtech but just the fronts