Quote:
Originally Posted by carlsbadfrontier
I dont know that I made myself clear... Inside the factory Frontier tube is a 12in piece of 2in OD tube. The bolts that you see go through the mounting plate, through the factory tube, through the steel tube and end with nuts attached on the inside.
If anything at all was going to fail, it would be the plastic factory feet. I am trying to find a way to have a rear brace that would be able to move from the up to the down position. I cant find any decent pics of a folding light cage, and I just cant figure it out.
I will try to find a way to do it before next weekend when I cut this one back apart.
|
I understood your original post fine, well on the second run thru I did. The two bolts I was refering to were used as the pivot points, one on each side. I assume it would be a pain to have to stop and tighten them up all the time. IDK what type of link system would be needed so that it could move with light assembly. I am sure you will figure something out and it will look awesome.
Side Note: Any word on the guys who tried to jack your light last week?