[TerribleOne]

I recently acquired an m226 that I will be putting a TruTrac and more than likely the 3:73 gears in....but there is one little issue. The m226 and 4wd trucks have a 4 bolt where my c200 has a 6 bolt. Sorry, old news for a bunch of you I know, but I figured this was the best place to start.

Other than a custom drive shaft anybody have any ideas? I was going to wait to have the trutrac and gears put in than figure out the driveshaft issue afterwards, but if it is less difficult than I think it will be then I will just go ahead and get it all done sooner than later. If a custom driveshaft is pretty much the only option, anyone have any ideas what I should expect to pay for one?


Thanks for any input you guys may have.