I'll start from the throttle body and go to the filter.
1. 1 2 3/4" to 3" coupler. Like this
one. I had this.
2. 1 3" vacuum adaptor. Like this
one. I bought this at Autozone.
This comes with a plastic coupler. I will relace the coupler though.
3. 1 90* elbow. Like this
one. I bought this at Autozone.
4. 1 4" straight tube. Like this
one. I bought this at Autozone. It
comes with a plastic coupler. I will replace the coupler though.
5. 1 3" universal coupler. Like this
one. I had this.
6. 1 Mass air flow sensor tube from an '04-'06 2.5l Sentra or Altima.
I bought mine on eBay. The good thing is the tube comes with the
sensor. These are expensive. The seller I bought mine from has 2
auctions right now. This
one and this
one. $39.95 + $8 shipping.
The good thing about this is the sensors are the same as ours.
So we can have a spare.
7. 1 MAF tube filter adapter. Like this
one. I used 2 1/2" bolts and
2 1" bolts to secure it to the MAF tube. The 1" on the bottom
for the brackets.
8. 1 Filter. Make sure it will fit on the sensor tube adapter. I used an
AEM Dryflow. Like this
one.
9. 2 Custom made brackets. I used some 1/4" x 1" flat steel. The
bottom one was 6". The side one was 9". I just bent them to fit.
2 nuts to secure it to the MAF tube. (see #7) 2 bolts to secure it
to the truck.
10. 2 Rubber grommets. I used these between the brackets and truck
body. To give the intake some flex and dampening.
Good luck to all. Post some pics when you get it done.
*The only problem I can forsee is the MAF plug on your trucks. On my first try at a CAI, I extended my wires by cutting and soldering about 10" of extra wire to reach. So, I'm not sure if your wires will reach where I have my MAF tube. They are packed in a track behind the rubber tube on top of the motor. Make sure you look to see if these will reach before doing this. You may have to extend yours too or put the MAF tube closer to the throttle body.
I apologize for not remembering this sooner.
