K&N 57 series review: Good intake for the money, decent SOTP incresses. Better trottle responce. Intake fit very well, the instructions were spot on. Putting on the rubber gasket around the sheild takes some time. Total install for me was about 45 mins in my driveway with basic tools. Tools you'll need a 10mm and a 14mm socket a flat head and philips head screw drivers plus some others just cant remember right now. Decent intake just unhappy with the open air box.
Its not the best photo but this is the K&N Installed
Volant review: Took the K&N out and changed to the Volant intake. Finish on the intake was very good. SOTP the intake had a little more power then the K&N and a good ammount over stock along with much better lower end when pulling hills with trailer. The install instructions left a lot be be desired. To install this intake right you need to remove the grill shell. Remove a plastic baffel that forces are into the side of the raditor. Also depending on your model might need to relocate or force move the horn a little. The tube is a little had to get to fit just right on both sides. Total install time is about an hour and a half to install with removing and reinstalling the grill. Tools: you need a 10mm and a 14mm socket a flat head and philips head screw drivers maybe some others too. So far very happy with it.
Installed
Edit: I also have a Magnaflow cat back exhaust system that might give slightly differnt SOTP mesurments than a stock exhaust
